What we don’t see when turning HTA at a microscopic level is that a heat pocket is being created between the cutting edge and the chip being formed. This heat pocket is preventing coolant from targeting the cutting edge. What HPC does is break through the heat pocket and get coolant to where it needs to be. External flood coolant will not be able to break through the heat pocket, which will cause the coolant to evaporate at these cutting temperatures. With pinpoint coolant placement, we can then see improvements to chip control, extended insert life, and increased cutting parameters.
Related Glossary Terms
Fluid that reduces temperature buildup at the tool/workpiece interface during machining. Normally takes the form of a liquid such as soluble or chemical mixtures (semisynthetic, synthetic) but can be pressurized air or other gas. Because of water’s ability to absorb great quantities of heat, it is widely used as a coolant and vehicle for various cutting compounds, with the water-to-compound ratio varying with the machining task. See cutting fluid; semisynthetic cutting fluid; soluble-oil cutting fluid; synthetic cutting fluid.
Workpiece is held in a chuck, mounted on a face plate or secured between centers and rotated while a cutting tool, normally a single-point tool, is fed into it along its periphery or across its end or face. Takes the form of straight turning (cutting along the periphery of the workpiece); taper turning (creating a taper); step turning (turning different-size diameters on the same work); chamfering (beveling an edge or shoulder); facing (cutting on an end); turning threads (usually external but can be internal); roughing (high-volume metal removal); and finishing (final light cuts). Performed on lathes, turning centers, chucking machines, automatic screw machines and similar machines.