Look Ahead: 3D printing picks up the pace

Author Michael C. Anderson
Published
June 20, 2017 - 03:45pm

One reason additive manufacturing of metal parts isn’t more widespread is that, for many manufacturers, it’s too slow and expensive compared to subtractive methods. Laser sintering, the most-popular AM method, builds a part layer by layer at the pinpoint of a laser beam. It’s a slow process that uses metal powders specially formulated to have a consistent grain size. Those powders are not cheap. 

Desktop Metal Inc., a 2-year-old startup, developed a different method of metal 3D printing that it calls an “office-friendly” system for rapid prototyping. The Desktop Metal (DM) Studio system is based on a new approach—Single Pass Jetting (SPJ), which was created by the inventors of the binder-jetting and the single-pass inkjet processes. The company also offers DM Production, a printer for the manufacturing market it claims is 100 times faster than current laser- sintering machines.



The DM Studio System allows rapid prototyping with the same alloys used in production. Image courtesy of Desktop Metal.


In this process, the component is first printed completely and then sintered in a microwave-enhanced furnace. The system relies on Bound Metal Deposition, a proprietary process from DM that’s similar to the widely used fused-deposition modeling additive process for plastics. 

SPJ is bidirectional. It combines all the necessary steps for printing so that whenever there is movement, there is printing. Two full-width print bars that contain more than 32,000 jets work in conjunction with powder spreaders. In a single quick pass across the build area, they spread powder and print, jetting millions of droplets per second. The production system prints at up to 8,200 cm3/hr. (500 in.3/hr.). 

The bulk-sintering process achieves densities greater than 98 percent. Parts perform similar to wrought alloys and it’s possible to fine-tune part density, according to the company.

Cost savings come from the system’s reliance on using existing materials for metal injection molding rather than developing new, specially formulated metal powders. This approach opens up an ecosystem of low-cost, high-quality alloys—from steels and aluminum to superalloys and titanium—with a mature supply chain and well-studied process controls. The company claims DM Production is 20 times less expensive to use than existing technology.

For more information about Desktop Metal Inc., Burlington, Mass., visit www.desktopmetal.com or call (978) 224-1244.

Related Glossary Terms

  • alloys

    alloys

    Substances having metallic properties and being composed of two or more chemical elements of which at least one is a metal.

  • lapping compound( powder)

    lapping compound( powder)

    Light, abrasive material used for finishing a surface.

  • sintering

    sintering

    Bonding of adjacent surfaces in a mass of particles by molecular or atomic attraction on heating at high temperatures below the melting temperature of any constituent in the material. Sintering strengthens and increases the density of a powder mass and recrystallizes powder metals.

  • superalloys

    superalloys

    Tough, difficult-to-machine alloys; includes Hastelloy, Inconel and Monel. Many are nickel-base metals.

Author

Former Senior Editor
734-606-9673

Michael Anderson, former senior editor at Cutting Tool Engineering magazine, holds a master's degree in written communication from Eastern Michigan University. He has been professionally writing about manufacturing technology since 1998, including more than 10 years at the Society of Manufacturing Engineers.