For the 10th episode of The CNC Chef, Bob Warfield of the CNCCookbook discusses the challenges presented when drilling deep holes. Among them: clearing the chips, getting coolant down deep, and holding tolerances on position, diameter and surface finish. As Warfield observes in this episode, "all of this means we need to use some special strategies whenever we have to go more than 5 diameters deep, and that's what this video is all about."
About The CNC Chef Video Series: Bob Warfield founded CNCCookbook.com and built it up to be one of the most popular CNC Blogs on the Internet. Thanks to his work with CNCCookbook and the G-Wizard software series, Warfield routinely receives questions from shops all over the world. For more information about the CNC Chef, visit his website here.
Related Glossary Terms
- computer numerical control ( CNC)
computer numerical control ( CNC)
Microprocessor-based controller dedicated to a machine tool that permits the creation or modification of parts. Programmed numerical control activates the machine’s servos and spindle drives and controls the various machining operations. See DNC, direct numerical control; NC, numerical control.
- coolant
coolant
Fluid that reduces temperature buildup at the tool/workpiece interface during machining. Normally takes the form of a liquid such as soluble or chemical mixtures (semisynthetic, synthetic) but can be pressurized air or other gas. Because of water’s ability to absorb great quantities of heat, it is widely used as a coolant and vehicle for various cutting compounds, with the water-to-compound ratio varying with the machining task. See cutting fluid; semisynthetic cutting fluid; soluble-oil cutting fluid; synthetic cutting fluid.
MEDIA
