Cutting Tool Engineering

Cutting Tool Engineering | April 2013 | Kennametal

Kennametal quick-change

Kennametal shows a side-by-side comparison of its KM-Micro/Mini quick-change system versus a standard tool in this 2-minute demonstration, courtesy of Kennametal. While the KM-Micro/Mini tool change is complete in just half a minute, the standard tool requires 2 minutes to change, set up and gage the tool.

CUTTING TOOL ENGINEERING Magazine is protected under U.S. and international copyright laws. Before reproducing anything from this Web site, call the Copyright Clearance Center Inc.
at (978) 750-8400.