Cutting Tool Engineering

June 2011 / Video Showcase / Walter USA LLC

Walter USA LLC
Walter Titex XD drills reach a drilling depth of 70xD.

The XD70 is currently being produced as a special tool in diameters ranging from 0.197" to 0.472" (5mm to 12mm). Two tip coatings are available depending on the material: TFP for soft steels and XPL for cast iron.


About the CTE Plus Video Showcase: The videos in this showcase were submitted by our advertisers and are presented here by Cutting Tool Engineering magazine as a service to our readers and Web-site visitors.

CUTTING TOOL ENGINEERING Magazine is protected under U.S. and international copyright laws. Before reproducing anything from this Web site, call the Copyright Clearance Center Inc.
at (978) 750-8400.